Command Line Reference Guide

static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on M I/O Aggregator.
Example
Dell#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ip multicast-cam stack-unit
Displays content-addressable memory (CAM) entries.
Syntax
show ip multicast-cam stack-unit 0-5 port-set pipe-number [ip-
address mask [longer-prefixes] | detail | member-info |
summary]
Parameters
0-5 Enter the stack-unit ID, from 0 to 5.
pipe-number
Enter the number of the Port-Pipe number. The range is
from 0 to 0.
ip-address
mask [longer-
prefix]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only.
Enter the keyword longer-prefixes to view routes with a
common prefix.
detail
Enter the keyword detail to display the group index ID
used by the ecmp routes int he CAM.
member-info Enter the keyword member-info to display the group index
used by the ecmp, the number of egress ports (members) for
the ecmp, and the port details of each member. The detail
information under
member-info will give the MAC address,
VLAN ID and gateway of every member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
IPv4 Routing
193