Command Line Reference Guide

Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Dell#
Usage
Information
The following describes the show ip interface brief command shown in the
following example.
Fields Description
Interface Displays type of interface and the associated slot and port
number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the configuration is read from the saved
configuration.
Status States whether the interface is enabled (up) or disabled
(administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method Status Protocol
TenGigabitEthernet 0/1 unassigned NO None up down
TenGigabitEthernet 0/2 unassigned YES None up up
TenGigabitEthernet 0/3 unassigned YES None up up
TenGigabitEthernet 0/4 unassigned NO None up down
TenGigabitEthernet 0/5 unassigned NO None up down
TenGigabitEthernet 0/6 unassigned NO None up down
TenGigabitEthernet 0/7 unassigned NO None up down
TenGigabitEthernet 0/8 unassigned NO None up down
TenGigabitEthernet 0/9 unassigned NO None up down
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
192
IPv4 Routing