Command Line Reference Guide

show config (from PROTOCOL LLDP mode)
Displays the LLDP configuration.
Syntax
show config
Command
Modes
PROTOCOL LLDP
Example
Dell(conf-lldp)#show conf
!
protocol lldp
Dell(conf-lldp)#
show interfaces
Displays information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan followed
by a number from 1 to 4094.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. The range is from 1 to
128.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator
Usage
Information
Use this show interfaces command for details on a specific interface. Use the
show interfaces stack-unit command for details on all interfaces on the
designated stack unit.
On the M I/O Aggregator, the show interface output displays incorrect rate
information details over time for link monitoring when the rate-interval is
configured for 5 seconds. Dell Networking recommends using higher rate-intervals
such as 15 to 299 seconds to minimize the errors seen.
Interfaces
163