Command Line Reference Guide

b - Display bytes r - Display pkts/bytes per sec
l - Page up a - Page down
name
Assign a name to the Default VLAN.
Syntax
namevlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-name Enter up to 32 characters as the name of the VLAN.
Defaults Not configured.
Command
Modes
INTERFACE VLAN
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
This CLI applies only to the Default VLAN.
To display information about a named VLAN, enter the show vlan command with
the name parameter or the
show interfaces description command.
Related
commands
default vlan-id—Assigns a descriptive text string to the interface.
interface vlan— Configures a VLAN.
show vlan— Displays the current VLAN configurations on the switch.
negotiation auto
Enable auto-negotiation on an interface.
Syntax
negotiation auto
To disable auto-negotiation, enter no negotiation auto command.
Defaults Enabled.
Command
Modes
INTERFACE
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator
158
Interfaces