Command Line Reference Guide

port-channel
number
Enter the keyword port-channel followed by an existing LAG
number.
Enter this keyword/variable combination twice, identifying
the two LAGs to be paired.
Defaults none
Command
Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf)#port-channel failover-group
Dell(conf-po-failover-grp)#group 1 port-channel 1 port-channel
2
Dell(conf-po-failover-grp)#
Related
commands
show interfaces port-channel— Displays information on configured Port Channel
groups.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands for
a range of interface.
Syntax
interface range interface, interface,...
To delete a description, enter no description command.
Parameters
interface,
interface,...
Enter the keyword interface range and one of the interfaces
— slot/port, port-channel or VLAN number. Select the range
of interfaces for bulk configuration. You can enter up to six
comma separated ranges—spaces are not required between
the commas. Comma-separated ranges can include VLANs,
port-channels and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range
tengigabitethernet 0/1 - 5
is valid; interface
range tengigabitethernet 0/1-5 is not valid.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
150
Interfaces