Command Line Reference Guide

Defaults Without a specific interface specified, the command clears all interface counters.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
• For the management interface on the stack-unit, enter
the keyword management ethernet followed by slot/
port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. Range: 1-128
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
clear mac-address-table dynamic
Clear the MAC address table of all MAC addresses learned dynamically.
Syntax
clear mac-address-table dynamic {interface tengigabitethernet
slot/port-id}
Parameters
interface Enter the keyword interface range and one of the
interfaces — slot/port, port-channel or VLAN number. Select
the range of interfaces for bulk configuration. You can enter
up to six comma separated ranges-spaces are not required
between the commas. Comma-separated ranges can
include VLANs, port-channels and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range tengigabitethernet 0/1
- 5 is valid; interface range tengigabitethernet 0/1-5 is not
valid.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Command
Modes
EXEC Privilege
Interfaces
147