Command Line Reference Guide

Usage
Information
In the M I/O Aggregator, the DHCP client is enabled only on the default vlan and
management interface 0/0. Use the ip address command to assign a static ip
address that overwrites the dynamically assigned IP address.
clear ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax clear ip dhcp client statistics {all|interface type slot/port}
Parameters
all Clear DHCP client statistics on all DHCP client-enabled
interfaces on the switch.
interface type
slot/port
Clear DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command
Modes
EXEC Privilege
Default None
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
debug ip dhcp client events
Enable the display of log messages for the following events on DHCP client interfaces:
• IP address acquisition
• IP address release
• Renewal of IP address and lease time
• Release of an IP address
Syntax
debug ip dhcp client events [interface type slot/port]
122
Dynamic Host Configuration Protocol