Command Line Reference Guide

Field Description
Priorities 802.1p priorities configured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
show stack-unit stack-ports ets details
Displays the ETS configuration applied to egress traffic on stacked ports, including ETS operational mode
on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and
scheduler type.
Syntax
show stack-unit {all | stack-unit} stack-ports all ets details
Parameters
stack-unit Enter the stack unit identification. The range is from 0 to 5.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell# show stack-unit all stack-ports all ets details
Stack unit 1 stack port all
Max Supported TC Groups is 4
Number of Traffic Classes is 1
Admin mode is on
Admin Parameters:
--------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,3,4,5,6,7 100% ETS
1 - -
2 - -
3 - -
4 - -
5 - -
6 - -
Data Center Bridging (DCB)
119