Administrator Guide

To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in
Interface configuration mode.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command Modes PROTOCOL LLDP
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
Usage
Information
This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x10
Command Modes PROTOCOL LLDP
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O Aggregator.
Usage
Information
This command is available at the global level only.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
Data Center Bridging (DCB) 95