Administrator Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator

advertise dcbx-tlv

On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.

Syntax

advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]

[ets-conf | ets-reco | pfc]

To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.

Parameters

{ets-conf | ets-

reco | pfc}

Enter the PFC and ETS TLVs advertised, where:

● ets-conf: enables the advertisement of ETS configuration TLVs.

● ets-reco: enables the advertisement of ETS recommend TLVs.

● pfc: enables the advertisement of PFC TLVs.

Defaults All PFC and ETS TLVs are advertised.

Command Modes PROTOCOL LLDP

Supported Modes Programmable-Mux (PMUX)

Command

History

Version Description

9.4(0.0) Supported on the FN I/O Aggregator.

9.2(0.0) Introduced on the M I/O Aggregator.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage

Information

You can configure the transmission of more than one TLV type at a time; for example: advertise

dcbx-tlv ets-conf ets-reco.

You can enable ETS recommend TLVs (ets-reco) only if you enable ETS configuration TLVs (ets-

conf). To disable TLV transmission, use the no form of the command; for example, no advertise

dcbx-tlv pfc ets-reco.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the

DCBX configuration on a port, use the show interface dcbx detail command.

bandwidth-percentage

Assign a percentage of weight to the class/queue.

Syntax

bandwidth-percentage percentage

To remove the bandwidth percentage, use the no bandwidth-percentage command.

Parameters

percentage

Enter the percentage assignment of weight to the class/queue. The range is from 1

to 100% (granularity 1%).

Defaults none

Command Modes CONFIGURATION (conf-qos-policy-out)