Administrator Guide

Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are
prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3),
minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default
setting for those parameters, press the ENTER key.
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
---------------------------------------------------------------------------------
---------
Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte
packets
---------------------------------------------------------------------------------
---------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms 001.000 ms
001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000
ms
4 www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms
Dell#
Related
Commands
ping — Tests the connectivity to a device.
undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command Modes
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write {memory | terminal}
Parameters
memory
Enter the keyword memory to copy the current running configuration to the
startup configuration file. This command is similar to the copy running-config
startup-config command.
terminal Enter the keyword terminal to copy the current running configuration to the
terminal. This command is similar to the show running-configcommand.
Control and Monitoring 73