Administrator Guide

Defaults all
Command Modes EXEC
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed
first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic
information is displayed for router ports only; not for management interfaces. The traffic statistics are
collected only after the debug cpu-traffic-stats command is executed; not from the system
bootup.
NOTE: After debugging is complete, use the no debug cpu-traffic-stats command to shut
off traffic statistics collection.
Example
Dell#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on TenGigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
Dell#
Related
Commands
debug cpu-traffic-stats — enables CPU traffic statistics for debugging.
show debugging
View a list of all enabled debugging processes.
Syntax
show debugging
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show debug
Generic IP: (Access List: test)
IP packet debugging is on for (Access List: test)
TenGigabitEthernet 0/16
ICMP packet debugging is on for
TenGigabitEthernet 0/16
OSPF:1
OSPF packet debugging is on
DHCP:
DHCP debugging is on
Dell#
54 Control and Monitoring