Administrator Guide

● Y: Do validate reply data.
The default is No.
pattern pattern Enter the IPv4 data pattern. The range is from 0 to FFFF. The default is 0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is from 52 to 15359
bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is from 53 to
15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to 15308 seconds.
ointerface Enter the outgoing interface for multicast packets. Enter the IP address in A.B.C.D
format.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults See parameters above.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
When you enter the ping command without specifying an IP address (Extended Ping), you are prompted
for a target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout (in seconds), and
for Extended Commands. For information on the ICMP message codes that return from a ping
command, refer to Internet Control Message Protocol (ICMP) Message Types.
Example (IPv4)
Dell#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
::
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
Dell#
reload
Reboot the Dell Networking OS.
Syntax
reload
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
50 Control and Monitoring