Administrator Guide

ip telnet server enable
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
interface Enter the following keyword and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
● For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Related
Commands
telnet — telnets to another device.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set
the access conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port.
The console option is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure a virtual
terminal line for Telnet sessions.
The system supports 10 Telnet sessions.
48 Control and Monitoring