Administrator Guide

buffer unit and port (1-56), and queue (0-14 or all), and buffer-
info. The buffer unit default is 1.
fpga Enter the keyword fpga, to display fpga details.
fru Enter the keyword fru, to display fru details.
phy-firmware-
version
Each member of the stack is updated automatically with the latest firmware while
booting as well as during OIR. To dump the physical firmware version for stack
units, enter the keywords phy-firmware-version.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics , optionally followed by the
keywords stack port and its number from 0 to 52 to display the data plane
statistics, which shows the High Gig (Higig) port raw input/output counter
statistics to which the stacking module is connected.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics, to display the Management
plane input/output counter statistics of the Private Management interface.
cpu private-
mgmt statistics
Enter the keywords cpu private-mgmt statistics, to display the
Management plane input/output counter statistics of the Private Management
interface.
drops [unit 0-0
[port 1-56 ]]
Enter the keyword drops to display internal drops on the selected stack member.
Optionally, use the keyword unit with 0 to select port-pipe 0, and then use port
1-56 to select a port on that port-pipe.
stack-port 33–56 Enter the keywords stack-port and a stacking port number to select a stacking
port for which to display statistics. Identify the stack port number as you would to
identify a 10G port that was in the same place in one of the rear modules.
NOTE: You can identify stack port numbers by physical inspection of the rear
modules. The numbering is the same as for the 10G ports. You can also inspect
the output of the show system stack-ports command.
unit 0–0
{counters |
details | port-
stats [detail] |
register}
Enter the keyword unit then 0 for port-pipe 0, and then enter one of the
following keywords to troubleshoot errors on the selected port-pipe and to give
status on why a port is not coming up to register level: counters, details,
port-stats [detail], or register.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Example (show
hardware stack-
unit phy-
firmware-version
Command)
Dell#show hardware stack-unit 1 phy-firmware-version
PortNumber Status Programmed Version SW Version
=======================================================================
41 Present 01.05 01.05
42 Present 01.05 01.05
43 Present 01.05 01.05
44 Present 01.05 01.05
45 Not Present N/A N/A
46 Not Present N/A N/A
47 Not Present N/A N/A
48 Not Present N/A N/A
49 Present 01.06 01.06
50 Present 01.06 01.06
51 Present 01.06 01.06
52 Present 01.06 01.06
53 Present 01.06 01.06
Debugging and Diagnostics 321