Administrator Guide

IGMP Tunnel PDUs sent: 0
IGMP Tunnel PDUs rcvd: 0
VLT ARP Statistics
--------------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP Tunnel Pkts sent Non Vlt:0
ARP Tunnel Pkts Rcvd Non Vlt:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:2
ARP Reg Request rcvd:1
VLT IOA Statistics
-------------------------------
IOA Info Pkts sent: 5
IOA Info Pkts Rcvd: 7
IOA Reg Request sent: 2
IOA Reg Request rcvd: 2
IOA Reg Response sent: 2
IOA Reg Response rcvd: 1
VLT NDP Statistics
--------------------
NDP NA VLT Tunnel Pkts sent:0
NDP NA VLT Tunnel Pkts Rcvd:0
NDP NA Non-VLT Tunnel Pkts sent:0
NDP NA Non-VLT Tunnel Pkts Rcvd:0
Ndp-sync Pkts Sent:0
Ndp-sync Pkts Rcvd:0
Ndp Reg Request sent:2
Ndp Reg Request rcvd:1
VLT multicast not enabled
stack-unit iom-mode
Set the Aggregator operating mode to VLT mode.
Syntax
stack-unit <unit-number> iom-mode vlt
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5. The default
is 0.
vlt Enable virtual link trunking mode.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage
Information
This command resets the operating mode to VLT. You must reboot the Aggregator after using this
command.
system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
312 Virtual Link Trunking (VLT)