Administrator Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control broadcast
[packets_per_second in] command.
Parameters
packets_per_sec
ond
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on the interface.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_sec
ond
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
storm-control unknown-unicast (Interface)
Configure percentage of unknown-unicast traffic allowed on the interface.
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control unknown-
unicast [packets_per_second in] command.
Parameters
packets_per_sec
ond
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554431.
Storm Control 289