Administrator Guide

Supported Modes All Modes
Command
History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage
Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Related
Commands
● reload – reboots Dell Networking Operating System (OS).
● show system – displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-5 renumber 0-5
Parameters
0-5 The first instance of this value is the stack member unit identifier, from 0 to 5, of
the switch that you want add to the stack. The range is from 0 to 5. The second
instance of this value is the desired new unit identifier number.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators.
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered, only
that specific unit is reset and comes up with the new unit number.
Example
Dell#stack-unit 5 renumber 4
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
● reload – reboots Dell Networking Operating System (OS).
● reset stack-unit – resets the designated stack member.
● show system – displays the current status of all stack members or a specific member.
286 Stacking Commands