Administrator Guide

Example
Dell#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/33
1 0/37
2 0/41
3 0/45
Dell#
Related
Commands
reload— reboots the system.
show system— displays the current status of all stack members or a specific member.
stack-unit iom-mode
Toggle the Aggregator operating mode between programmable multiplex, standalone, stack, and VLT modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack | standalone |
vlt]
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5.
programmable-
mux
Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command Modes
● CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take effect.
Dell(conf)#
Dell#
Related
Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specific member.
284 Stacking Commands