Administrator Guide

Usage
information
This command is supported on the M I/O, FN410S, and FN410T Aggregators
Example
Dell#show system stack-unit all iom-mode ?
| Pipe through a command
<cr>
Dell#show system stack-unit all iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 stack stack
1 stack stack
2 stack stack
3 stack stack
4 Not Present
5 Not Present
Dell#
show system stack-unit iom-uplink-speed
Display the uplink speed of the LAG bundles configured on the Flex IO modules installed on the Aggregator.
Syntax
show system stack-unit unit-number iom-uplink-speed
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is from 0 to 5.
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator
Usage
Information
The value under the Boot-speed field in the output of the show command indicates the uplink speed that
is currently effective on the LAG bundles, whereas the value under the Next-Boot field indicates the
uplink speed that is applicable for the LAG bundle after the next reboot of the switch.
Example
Dell# show system stack-unit 0 iom-uplink-speed
Unit Boot-speed Next-Boot
------------------------------------------------
0 10G 40G
show system stack-unit stack-group
Displays the stack-groups present/configured for a M I/O Aggregator stack unit.
Syntax
show system stack-unit unit-number stack-group [configured]
Parameters
unit number <0–
5>
Enter the number of the member stack unit. The range is from 0 to 5.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Stacking Commands 283