Administrator Guide

show system stack-ports
Display information about the stacking ports on all switches in the M I/O Aggregator switch stack..
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the command output without
the Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface
and Connection fields.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show interfaces command shown in the following example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone.
Interface The unit/port ID of the connected stack port on this unit.
Link Speed Link Speed of the stack port (10 or 40) in Gb/s.
Admin Status The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected.
Example
Dell# show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/33 40 up down
0/37 1/37 40 up up
1/33 40 up down
1/37 0/37 40 up up
Dell#
Example (Status)
Dell# show system stack-ports status
Topology: Daisy chain
Interface Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/33 40 up down
0/37 40 up up
1/33 40 up down
1/37 40 up up
Example
(Topology)
Dell# show system stack-ports topology
Topology: Daisy chain
Interface Connection Trunk
Group
0/33
0/37 1/37
1/33
Stacking Commands 281