Administrator Guide

Related
Commands
policy-map-output — creates an output policy map.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables
Policy-Map-Output Configuration mode (conf-policy-map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-output
Create a QoS output policy.
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name
command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To specify the name of the output QoS policy, use this command. After the output policy is specified,
rate-limit, bandwidth-percentage, and WRED can be defined. This command enables Qos-Policy-Output
Configuration mode — (conf-qos-policy-out).
248 Quality of Service (QoS)