Administrator Guide

disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
debug lldp interface — debugs LLDP.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The
rate is from 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the interface
dead. The range is from 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
238 Link Layer Discovery Protocol (LLDP)