Administrator Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output then one of the following interfaces for which traffic is
forwarded:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology
change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the
Dell Networking OS Configuration Guide.
Layer 2 231