Administrator Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator

221

222

223

224

225

226

227

228

229

230

Layer 2

This chapter describes commands to configure Layer 2 features.

This chapter contains the following sections:

● MAC Addressing Commands

● Virtual LAN (VLAN) Commands

Topics:

• MAC Addressing Commands

• Virtual LAN (VLAN) Commands

• clear mac-address-table dynamic

• description

• mac-address-table aging-time

• mac-address-table static

• mac-address-table station-move refresh-arp

• show cam mac stack-unit

• show mac-address-table

MAC Addressing Commands

The following commands are related to configuring, managing, and viewing MAC addresses:

● clear mac-address-table dynamic

● mac-address-table aging-time

● mac-address-table static

● mac-address-table station-move refresh-arp

● show cam mac stack-unit

● show mac-address-table

Virtual LAN (VLAN) Commands

The following commands configure and monitor virtual local area networks (VLANs). VLANs are a virtual interface and use many

of the same commands as physical interfaces.

You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are

not supported on a VLAN.

clear mac-address-table dynamic

Clear the MAC address table of all MAC addresses learned dynamically.

Syntax

clear mac-address-table dynamic {address mac-address | all | interface

interface | vlan vlan-id}

Parameters

address

mac-

address

Enter the keyword address followed by a MAC address in nn:nn:nn:nn:nn:nn

format.

all Enter the keyword all to delete all MAC address entries in the MAC address table.

Layer 2 229