Administrator Guide

static (OPTIONAL) Enter the keyword static to view only routes configured by the ip
route command.
summary (OPTIONAL) Enter the keyword summary.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show ip route all command in the following example.
Field Description
(undefined) Identifies the type of route:
● C = connected
● S = static
● R = RIP
● B = BGP
● IN = internal BGP
● EX = external BGP
● LO = Locally Originated
● O = OSPF
● IA = OSPF inter area
● N1 = OSPF NSSA external type 1
● N2 = OSPF NSSA external type 2
● E1 = OSPF external type 1
● E2 = OSPF external type 2
● i = IS-IS
● L1 = IS-IS level-1
● L2 = IS-IS level-2
● IA = IS-IS inter-area
● * = candidate default
● > = non-active route
● + = summary routes
Destination Identifies the route’s destination IP address.
Gateway Identifies whether the route is directly connected and on which interface the route
is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Example
(Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
Dell#show ip route static ?
| Pipe through a command
<cr>
Dell#show ip route static
208 IPv4 Routing