Administrator Guide

show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number of
active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
Dell#
show ip multicast-cam stack-unit
Displays content-addressable memory (CAM) entries.
Syntax
show ip multicast-cam stack-unit 0-5 port-set pipe-number [ip-address mask
[longer-prefixes] | detail | member-info | summary]
Parameters
0-5 Enter the stack-unit ID, from 0 to 5.
pipe-number
Enter the number of the Port-Pipe number. The range is from 0 to 0.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only.
Enter the keyword longer-prefixes to view routes with a common prefix.
detail
Enter the keyword detail to display the group index ID used by the ecmp routes
int he CAM.
member-info Enter the keyword member-info to display the group index used by the ecmp,
the number of egress ports (members) for the ecmp, and the port details of each
member. The detail information under member-info will give the MAC address,
VLAN ID and gateway of every member port of the ecmp.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number routes which can be entered in to CAM.
206 IPv4 Routing