Administrator Guide

● For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For VLAN, enter the keyword vlan then by a number from 1 to 4094.
count value (OPTIONAL) Enter the keywords count then the count value. The ranges from 1 to
65534. The default is Infinity.
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
To stop packets from flooding the user terminal when debugging is turned on, use the count option.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40:
ip route
Assign a static route to the switch.
Syntax
ip route destination mask {ip-address | interface [ip-address]}[distance]
[permanent][tag tag-value]
To delete a specific static route, use the no ip route destination mask {address |
interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prefix format (/x) of the destination device’s IP
address.
ip-address Enter the IP address in dotted decimal format of the forwarding router.
interface
Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
● For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
distance (OPTIONAL) Enter a number as the distance metric assigned to the route. The
range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify the route is not removed,
even if the interface assigned to that route goes down. The route must be up
initially to install it in the routing table.
If you disable the interface with an IP address associated with the keyword
permanent, the route disappears from the routing table.
IPv4 Routing 201