Administrator Guide

IPv4 Routing
The aggregator supports both IPv4 and IPv6 routing and these are used only for the management purpose.
This chapter describes the IPv4 related commands. They are:
● clear tcp statistics
● debug ip dhcp
● debug ip icmp
● ip route
● management route
● show arp
● show ip management-route
● show ip multicast-cam stack-unit
● show ip interface
● show ip route
● show tcp statistics
Topics:
• clear tcp statistics
• debug ip dhcp
• debug ip icmp
• ip route
• management route
• show arp
• show ip interface
• show ip management-route
• show ip multicast-cam stack-unit
• show ip route
• show tcp statistics
clear tcp statistics
Clear the TCP counters.
Syntax
clear tcp statistics
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
debug ip dhcp
Enable debug information for DHCP relay transactions and display the information on the console.
Syntax
debug ip dhcp
14
IPv4 Routing 199