Administrator Guide

show interfaces port-channel
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief| description]
Parameters
channel-number For a Port Channel interface, enter the keyword port-channel followed by a
number. The range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number,
the state of the port channel, and the number of interfaces in the port channel.
description (OPTIONAL) Enter the keyword description to display interface information with
description.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage
Information
The following describes the show interfaces port-channel command shown in the following
example.
Field Description
Port-Channel 1... Displays the status of LAG. In the Example, the status of the LAG, LAG fate-
sharing group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group (“Failover-group”).
Internet
address...
States whether an IP address is assigned to the interface. If an IP address is
assigned, that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface, it is the line speed
of the interfaces in the port channel.
Members in
this...
Displays the interfaces belonging to this port channel.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing... Displays the time when the show interfaces counters were cleared.
Queueing
strategy.
States the packet queuing strategy. FIFO means first in first out.
packets input... Displays the number of packets and bytes into the interface.
Input 0 IP
packets...
Displays the number of packets with IP headers, VLAN tagged headers, and MPLS
headers. The number of packets may not add correctly because a VLAN tagged IP
packet counts as both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that
interface. This information is displayed over two lines.
Received 0... Displays the type and number of errors or other specific packets received. This
information is displayed over three lines.
Output 0... Displays the type and number of packets sent out the interface. This information is
displayed over three lines.
Interfaces 187