Administrator Guide

Example
Dell(conf-if-vl-1)#show config
!
interface Vlan 1
description a
no ip address
mtu 2500
shutdown
Dell(conf-if-vl-1)#
show config (from PROTOCOL LLDP mode)
Displays the LLDP configuration.
Syntax
show config
Command Modes PROTOCOL LLDP
Supported Modes All Modes
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf-lldp)#show conf
!
protocol lldp
Dell(conf-lldp)#
show interfaces
Displays information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN interface, enter the keyword vlan followed by a number from 1 to
4094.
● For a Port Channel interface, enter the keyword port-channel followed by a
number. The range is from 1 to 128.
Command Modes
● EXEC
● EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.6(0.0) Added support for Auto-LAG on the M I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator
182 Interfaces