Administrator Guide

Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds Enter the number of seconds between queries sent out. The range is from 1 to
18000. The default is 60 seconds.
Defaults 60 seconds
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds Enter the number of seconds for the maximum response time. The range is from 1
to 25. The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command
History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This command is the master on/off switch to enable IGMP snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, use the no ip igmp snooping enable command.
Internet Group Management Protocol (IGMP) 155