Administrator Guide

Related
Commands
show fc zoneset — displays the configured and active zoneset.
show fcoe-map — displays the fabric parameters.
fcoe-map
Create an FCoE map which contains the parameters used to configure the links between server CNAs and a SAN fabric. Apply
the FCoE map on a server-facing Ethernet port.
Syntax
fcoe-map map-name
Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes CONFIGURATION
INTERFACE
Supported Modes All Modes
Command
History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator.
Usage
Information
An FCoE map is a template to map FCoE and FC parameters in a converged fabric. An FCoE map
virtualizes upstream FC ports on an M I/O Aggregator NPIV proxy gateway to appear to downstream
server CNA ports as FCoE forwarder (FCF) ports on an FCoE network. When applied to FC and Ethernet
ports on an NPIV proxy gateway, an FCoE map allows the switch to operate as an FCoE-FC bridge
between an FC SAN and an FCoE network. It provides necessary parameters to FCoE-enabled servers
and switches to log in to a SAN fabric.
On an M I/O Aggregator NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and
server-facing Ethernet ports. Use the fcoe-map command to apply an FCoE map on an Ethernet port.
Use the fabric command to apply an FCoE map on an FC port.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN for storage traffic, the
destination SAN fabric (FC-MAP value), FCF priority, and the FIP keepalive (FKA) advertisement timeout.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in
Interface configuration mode.
NOTE: You cannot create fcoe-map in IOA mode. It can only be created in PMUX mode.
NOTE: In FCF F mode, you can create only one FCoE map. It doesn’t get created automatically. If
you try to create more than one map, an error message is displayed.
Related
Commands
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
feature fc
Enable feature fc with FPort functionality.
Syntax
feature fc fport domain-id range
Parameters
Range Enter the range from 1 to 239.
Command Modes CONFIGURATION
Supported Modes All Modes
134 FC FLEXIO FPORT