Administrator Guide

Parameters
map-name Maximum: 32 alphanumeric characters.
Defaults None
Command Modes INTERFACE FIBRE_CHANNEL
Supported Modes All Modes
Command
History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
Usage
Information
An FCoE map is a template used to map FCoE and FC parameters in a converged fabric. An FCoE map
virtualizes the upstream FC ports on an M I/O Aggregator NPIV proxy gateway to appear to downstream
server CNA ports as FCoE forwarder (FCF) ports on an FCoE network. When applied to FC and Ethernet
ports on an NPIV proxy gateway, an FCoE map allows the switch to operate as an FCoE-FC bridge
between an FC SAN and an FCoE network. It provides necessary parameters to FCoE-enabled servers
and switches to log in to a SAN fabric. Use the fcoe-map command to create an FCoE map.
On an M I/O Aggregator NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and
server-facing Ethernet ports. Use the fabric command to apply an FCoE map on an FC port. Use the
fcoe-map command to apply an FCoE map on an Ethernet port.
After you apply an FCoE map on an FC interface, when the port is enabled (no shutdown), the NPIV
proxy gateway starts sending FIP multicast advertisements on behalf of the FC port to downstream
servers to advertise the availability of a new FCF port on the FCoE VLAN.
To remove an FCoE map from an FC interface, enter the no fabric map-name command in Interface
configuration mode.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE maps.
fc alias
Create a zone alias name.
Syntax
fc alias ZoneAliasNamemember name
To delete a zone alias name, use the no fc zone ZoneAliasName command.
Parameters
ZoneAliasNamem
ember name
Enter the zone alias name.
Enter the WWPN, port ID, or domain/port.
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
Example
Syntax:
Dell(conf)#fc alias test12
Dell(conf-fc-alias-test12)#?
end Exit from configuration mode
exit Exit from Alias config mode
member Add Alias member
no Negate a command or set its defaults
show Show alias profile configuration
Dell(conf-fc-alias-test12)#member ?
WORD WWN(00:00:00:00:00:00:00:00), or portID(123000)
132 FC FLEXIO FPORT