Addendum

equally distributed to nonstrict-priority groups which have no configured
scheduler.
Related
Commands
• qos-policy-output ets — creates a QoS output policy.
• scheduler — schedules priority traffic in port queues.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port
Parameters
port-type Enter the keywords port-type then the slot/port
information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.3.0.0 Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch.
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on M I/O Aggregator and
MXL 10/40GbE Switch with the FC Flex IO module Ethernet interfaces. With auto-
detection of DCB enabled, a DCB map named ‘dcb-map’ is applied on all the
Ethernet interfaces on which the DCBx frames are observed.
Command
Modes
CONFIGURATION
INTERFACE
Command
History
Version 9.3.0.0 Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
502
Data Center Bridging (DCB) for FC Flex IO Modules