Addendum

show logging driverlog stack-unit
Display the driver log for the specified stack member.
S4810 S4820T Z9000
Syntax
show logging driverlog stack-unit unit#
Parameters
stack-unit
unit#
Enter the keywords stack-unit followed by the stack
member ID of the switch for which you want to display the
driver log. The range is from 0 to 1.
defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
This command displays internal software driver information, which may be useful
during troubleshooting switch initialization errors, such as a downed Port-Pipe.
terminal monitor
Configure the FTOS to display messages on the monitor/terminal.
Z-Series S4810 S4820T
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
defaults Disabled.
Command
Modes
• EXEC
• EXEC Privilege
424
Simple Network Management Protocol (SNMP) and Syslog