Addendum

no untagged port-channel id number
• Identify which port channels are members of VLANs.
EXEC Privilege mode
show vlan
Configuring VLAN Tags for Member Interfaces
To configure and verify VLAN tags for individual members of a port channel, perform the following:
1. Configure VLAN membership on individual ports
INTERFACE mode
FTOS(conf-if-te-0/2)#vlan tagged 2,3-4
2. Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through
an individual interface
INTERFACE mode
FTOS(conf-if-te-0/2)#switchport
3. Verify the manually configured VLAN membership (show interfaces switchport interface command).
EXEC mode
FTOS(conf)# interface tengigabitethernet 0/1
FTOS(conf-if-te-0/1)#switchport
FTOS(conf-if-te-0/1)# vlan tagged 2-5,100,4010
FTOS#show interfaces switchport te 0/1
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V -
VLT tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: True
Vlan membership:
Q Vlans
T 2-5,100,4010
FTOS#
Deleting or Disabling a Port Channel
To delete or disable a port channel, use the following commands.
• Delete a port channel.
CONFIGURATION mode
no interface portchannel channel-number
• Disable a port channel.
shutdown
When you disable a port channel, all interfaces within the port channel are operationally down also.
374
Link Aggregation Control Protocol (LACP)