Addendum

V - VLT tagged
Name: TenGigabitEthernet 3/20
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 20
T 10
Native VlanId: 20.
Dell(conf)#
Example
(unconfigure
the hybrid port)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged tengig 0/20
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged tengig 0/20
Dell(conf-if-vl-20)#interface tengig 0/20
Dell(conf-if-te-0/20)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2)
interfaces on the switch.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
stack-unit portmode
Split a single 40G port into 4-10G ports on the MXL switch.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. The range is 0 to 5.
NOTE: The MXL switch commands accept Unit ID
numbers from 0 to 5, though the MXL switch supports
stacking up to three units only with the Dell Networking
OS version 8.3.7.1.
number Enter the port number of the 40G port to be split. Enter one
of the following port numbers for the MXL switch: 48, 52, 56,
or 60.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Interfaces
345