Addendum

description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• dcb-input — creates a DCB PFC input policy.
• dcb-policy input — applies the output policy.
• dcb-output — creates a DCBETS output policy.
• dcb-policy output — applies the output policy.
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Defaults ETS mode is on.
Command
Modes
DCB OUTPUT POLICY
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you disable ETS in an output policy applied to an interface using the no ets
mode on command, any previously configured QoS settings at the interface or
global level takes effect. If you configure QoS settings at the interface or global
290
Data Center Bridging (DCB)