Addendum

Online Insertion and Removal (OIR) of the Management
Optic
The following table illustrates the system operations during various system states when the management
optic is inserted and removed. It also describes the functioning of the system before the introduction of
the management optic and the current working with the management optic type supported.
Table 6. Online Insertion and Removal (OIR) of the Management Optic
1.a Run-
time
No Optic present. Insert MGMT optic Speed CLI will be enabled. and
default speed config applied.
S.No During Earlier Operation Current Operation System Behavior
1.b Non – MGMT optic Insert MGMT optic As in 1.a
1.c MGMT optic Present Remove MGMT optic Disable speed CLI and remove
the speed config on that
interface.
1.d MGMT optic Removed Reinsert MGMT optic As in 1.a
1.e MGMT optic Removed Insert Non-MGMT
optic
No change.
2.a Bootup MGMT optic removed
during reload. Speed
configs still present in
startup-config.
Insert Non-MGMT
optic
First time when Non-MGMT optic
is inserted remove speed CLI
configs for that port.
2.b MGMT optic removed
during reload. Speed
configs still present in
startup-config.
Insert MGMT optic Enable speed CLI and update the
earlier configured speed.
S/W : Being ‘speed’ CLI is enabled
only during Optic poller event,
startup config might get applied
too early. This has to be taken
care.
2.c 10G before reload 40G after reload Speed config will be removed,
when the interface Te interface is
deleted.
The following table describes the different scenarios of operations with the management optic type of
the media port converter on the S6000 platform connected to the S50 device.
Table 7. Scenarios of Working of Management Optic Type
CASE
NO
Speed S6k T2 Bcm 54616s S50 Remarks
AN SP FD HD AN SP FD HD AN SP FD HD
Default config on both sides:
1 1G off 1G ON - ON Defaul
t
Advert
ise:
10M,
100M,
1G
Def
ault
Def
ault
ON Defau
lt
Advert
ise:
10M,
100M,
1G
def NA Works only
if auto ON
at both
sides
212
Management Port Media Converter