Addendum

Parameters
value (OPTIONAL) Enter the traffic value in kilobits per second. The
default is 10 packets per second. A value of zero (0) causes a
switchover on the first packet.
infinity (OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.3.0.0 Introduced on the S6000.
Usage
Information
This command is applicable to last hop routers on the shared tree towards the
rendezvous point (RP).
ip route bfd (for S6000)
Enable BFD for all neighbors configured through static routes.
S6000
Syntax
ip route bfd [interval interval min_rx min_rx multiplier value
role {active | passive}]
To disable BFD for all neighbors configured through static routes, use the no ip
route bfd [interval interval min_rx min_rx multiplier value
role {active | passive}] command.
Parameters
interval
milliseconds
(OPTIONAL) Enter the keywords interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system receives control packets from the
remote system. The range is from 50 to 1000. The default is
100.
multiplier value Enter the keywords multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
174
Miscellaneous Settings