Addendum

• If management EIS is enabled, this default route is added to the management EIS routing table and the
default routing table.
ARP learn enable
• When ARP learn enable is enabled the switch shall learn ARP entries for ARP Request packets even if
the packet is not destined to an IP configured in the box.
• ARP learn enable feature shallnot be applicable to the EIS routing table. It is applicable to the default
routing table only. This is to avoid unnecessary double ARP entries
Sflow
Sflow management application is supported only in standalone boxes and switch shall throw error
message if sflow is configured in stacking environment
application (for HTTP and ICMP)
Configure the management egress interface selection for HTTP and ICMP.
NOTE: Only the options that have been newly introduced are described here. For a complete
description on all of the keywords and variables that are available with this command, refer the
respective Command Reference Guide of the applicable platform of the Release 9.2.0.0
documentation set.
Z9000 S4810 S4820T
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all |
application-type} command.
Parameters
application-
type
Enter any of the following keywords:
• For HTTP, enter the keyword http.
• For ICMP, enter the keyword icmp.
all Configure all applications.
Defaults None.
Command
Modes
EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.3.
(0.0)
Added support for the HTTP and ICMP traffic on the Z9000,
S4810, and S4820T.
Egress Interface Selection (EIS) for HTTP and IGMP Applications
129