Users Guide

4 Specify the FC-MAP value used to generate a fabric-provided MAC address, which is required to send FCoE traffic from a server on
the FCoE VLAN to the FC fabric specified in Step 2.
FCoE MAP mode
fc-map fc-map-value
You must enter a unique MAC address prefix as the FC-MAP value for each fabric.
The range is from 0EFC00 to 0EFCFF.
The default is none.
5 Configure the priority used by a server CNA to select the FCF for a fabric login (FLOGI).
FCoE MAP mode
fcf-priority priority
The range is from 1 to 255.
The default is 128.
6 Enable the monitoring FIP keep-alive messages (if it is disabled) to detect if other FCoE devices are reachable.
FCoE MAP mode
keepalive
The default is FIP keep-alive monitoring is enabled.
7 Configure the time interval (in seconds) used to transmit FIP keepalive advertisements.
FCoE MAP mode
fka-adv-period seconds
The range is from 8 to 90 seconds.
The default is 8 seconds.
Zoning
The zoning configurations are supported for Fabric FCF Port mode operation on the MXL.
In FCF Port mode, the fcoe-map fabric map-name has the default Zone mode set to deny. This setting denies all the fabric
connections unless included in an active zoneset. To change this setting, use the
default-zone-allow command. Changing this
setting to all allows all the fabric connections without zoning.
Zoning is a mechanism to ensure only the nodes that are part of a zone can communicate with each other. Zoning prevents unauthorized
access of storage assets. A zone consists of members which are nodes that the adapter address, fabric address, interface, or alias
specifies. S5000 supports using World Wide Port Name (WWPN), Fibre Channel ID (FC-ID), or alias as members of a zone.
• WWPN: End device's port WWN name.
• FC-ID: Switch assigned 24-bit device FC address.
• Alias: User-defined name of a zone member.
NOTE
: The M I/O Aggregator does not support using WWNN or Domain/Port as members of a zone.
302 FC FLEXIO FPORT