Users Guide

• Configure the packets per second (pps) of multicast traffic allowed on C-Series and S-Series networks only.
CONFIGURATION mode
storm-control multicast packets_per_second in
• Configure the packets per second of unknown-unicast traffic allowed in or out of the network.
CONFIGURATION mode
storm-control unknown-unicast [packets_per_second in]
Configuring Storm Control from INTERFACE Mode
To configure storm control, use the following command.
You can only configure storm control for ingress traffic in INTERFACE mode. If you configure storm control from both INTERFACE and
CONFIGURATION mode, the INTERFACE mode configurations override the CONFIGURATION mode configurations.
• Configure storm control.
INTERFACE mode
• Configure the percentage of broadcast traffic allowed on an interface (ingress only).
INTERFACE mode
storm-control broadcast packets_per_second in
• Configure the percentage of multicast traffic allowed on C-Series or S-Series interface (ingress only) network only.
INTERFACE mode
storm-control multicast packets_per_second in
• Shut down the port if it receives the PFC/LLFC packets more than the configured rate.
INTERFACE mode
storm-control pfc-llfc pps in shutdown
NOTE
: PFC/LLFC storm control enabled interface disables the interfaces if it receives continuous PFC/LLFC packets. It
can be a result of a faulty NIC/Switch that sends spurious PFC/LLFC packets.
250 Storm Control