Users Guide

The following is an example of configuring object tracking for an IPv4 interface:
Dell(conf)#track 101 interface tengigabitethernet 7/2 ip routing
Dell(conf-track-101)#delay up 20
Dell(conf-track-101)#description NYC metro
Dell(conf-track-101)#end
Dell#show track 101
Track 101
Interface TenGigabitEthernet 7/2 ip routing
Description: NYC metro
The following is an example of configuring object tracking for an IPv6 interface:
Examples of Configuring Object Tracking for an IPv4 or IPv6 Interface
Dell(conf)#track 103 interface tengigabitethernet 7/11 ipv6
routing
Dell(conf-track-103)#description Austin access point
Dell(conf-track-103)#end
Dell#show track 103
Track 103
Interface TenGigabitEthernet 7/11 ipv6 routing
Description: Austin access point
Track an IPv4/IPv6 Route
You can create an object that tracks the reachability or metric of an IPv4 or IPv6 route.
You specify the route to be tracked by its address and prefix-length values. Optionally, for an IPv4 route, you can enter a VRF instance
name if the route is part of a VPN routing and forwarding (VRF) table. The next-hop address is not part of the definition of a tracked
IPv4/IPv6 route.
In order for an route’s reachability or metric to be tracked, the route must appear as an entry in the routing table. A tracked route is
considered to match an entry in the routing table only if the exact IPv4 or IPv6 address and prefix length match an entry in the table. For
example, when configured as a tracked route, 10.0.0.0/24 does not match the routing table entry 10.0.0.0/8. Similarly, for an IPv6 address,
3333:100:200:300:400::/80 does not match routing table entry 3333:100:200:300::/64. If no route-table entry has the exact IPv4/IPv6
address and prefix length, the tracked route is considered to be DOWN.
In addition to the entry of a route in the routing table, you can configure the UP/DOWN state of a tracked route to be determined in the
following ways:
• By the reachability of the route's next-hop router.
The UP/DOWN state of the route is determined by the entry of the next-hop address in the ARP cache. A tracked route is considered
to be reachable if there is an ARP cache entry for the route's next-hop address. If the next-hop address in the ARP cache ages out for
a route tracked for its reachability, an attempt is made to regenerate the ARP cache entry to see if the next-hop address appears
before considering the route DOWN.
• By comparing the threshold for a route’s metric with current entries in the route table.
The UP/DOWN state of the tracked route is determined by the threshold for the current value of the route metric in the routing table.
To provide a common tracking interface for different clients, route metrics are scaled in the range from 0 to 255, where 0 is
connected and 255 is inaccessible. The scaled metric value communicated to a client always considers a lower value to have priority
over a higher value. The resulting scaled value is compared against the configured threshold values to determine the state of a tracked
route as follows:
• If the scaled metric for a route entry is less than or equal to the UP threshold, the state of a route is UP.
• If the scaled metric for a route is greater than or equal to the DOWN threshold or the route is not entered in the routing table, the
state of a route is DOWN.
176
Object Tracking