Users Guide

Name: TenGigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This command does not clear the
counters captured by any SNMP program.
To clear the counters, use the following command in EXEC Privilege mode:
1 Clear the counters used in the show interface commands for all VLANs, and physical interfaces or selected ones.
Without an interface specified, the command clears all interface counters.
• (OPTIONAL) Enter the following interface keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-channel followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port numbers.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
EXEC Privilege mode
clear counters [interface]
When you enter this command, you must confirm that you want Dell Networking OS to clear the interface counters for the interface (refer
to the below clearing interface example).
Clearing an Interface:
Dell#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
Dell#
Enabling the Management Address TLV on All
Interfaces of an Aggregator
The management address TLV, which is an optional TLV of type 8, denotes the network address of the management interface, and is
supported by the Dell Networking OS. It is advertised on all the interfaces on an I/O Aggregator in the Link Layer Discovery Protocol
(LLDP) data units. You can use the show running-configuration command to verify that this TLV is advertised on all the
configured interfaces and the show lldp neighbors detail command to view the value of this TLV.
Enhanced Validation of Interface Ranges
You can avoid specifying spaces between the range of interfaces, separated by commas, that you configure by using the interface
range command. For example, if you enter a list of interface ranges, such as interface range fo 2/0-1,te 10/0,gi 3/0,fa
0/0
, this configuration is considered valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
122
Interfaces