Users Guide

ip telnet source-interface
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
interface Enter the following keyword and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Related Commands telnet — telnets to another device.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access
conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port.
The console option is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure a virtual terminal
line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure.
You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Supported Modes All Modes
Control and Monitoring 55