Users Guide

NOTE: Use this command only when you are working directly with a technical support representative
to troubleshoot a problem. Do not use this command unless a technical support representative
instructs you to do so.
disable
Return to EXEC mode.
Syntax
disable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of the Dell Networking OS. The range is
from 0 to 15. The default is 1.
Defaults 1
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of the Dell Networking OS. The range is
from 0 to 15. The default is 15.
Defaults 15
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands.
To protect against unauthorized access, use the enable password command to configure a password for the
enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15.
Related Commands enable password — configures a password for the enable command and to access a privilege level.
Control and Monitoring 49