Users Guide

SupportAssist Commands
Dell Networking OS supports the following SupportAssist mode commands.
activity
Move to the SupportAssist Activity mode for an activity. Allow the user to configure customized details for a specific activity.
Syntax
activity {activity-name}
To remove all customized detail for a specific activity, use the no activity {activity-name} command.
Parameters
activity-name
Enter one of the following keywords:
• Enter the keyword full-transfer to enable or disable full transfer. You can
create a custom file to transfer the outputs from a set of show commands. By
default, the full transfer runs once in every 30 days.
•
Enter the keyword core-transfer to enable or disable core transfer.
• Enter the keyword event-transfer to enable or disable event transfer. You can
create a custom file to monitor a set of events.
Command Modes SUPPORTASSIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
Introduced the core-transfer and event-transfer parameters.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON,
Z9500, MXL.
Usage Information
By default, each activity follows a set of default actions using a default schedule. Using this command, you can
customize the set of actions and disable a certain activity.
contact-company
Configure the contact information for the company.
Syntax
contact-company name {company-name}[company-next-name] ... [company-next-name]
To remove the contact company information, use the no contact-company command.
SupportAssist 381