Users Guide

Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is available only in PMUX mode.
By default, protocol lldp is enabled, To disable, use the no protocol lldp command.
When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute
the
no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet
then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV information, timers, and
LLDP tx and rx counters.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
Example
Dell (conf-if-te-1/31)#do show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
-------------------------------------------------------------------------
Te 1/37 FTOS TenGigabitEthernet 0/37 00:01:e8:05:40:46
Te 1/38 FTOS TenGigabitEthernet 0/38 00:01:e8:05:40:46
Te 1/39 FTOS TenGigabitEthernet 0/39 00:01:e8:05:40:46
Te 1/40 FTOS TenGigabitEthernet 0/40 00:01:e8:05:40:46
Dell (conf-if-te-1/31)#
show lldp statistics
Displays the LLDP statistical information.
Syntax
show lldp statistics
Defaults none
Command Modes EXEC Privilege
Link Layer Discovery Protocol (LLDP) 283